Instruction Guide for AVBBP with 19" x 36" |
|||||||||
 |
 |
||||||||
|
Remove endcaps & slide extrusion into center of
the channel and back of base.Tighten with allen key and replace endcaps.
|
Measure the length of the banners and then slide each
IH clamp down the middle channel of the extrusion and screw into place.
|
||||||||
 |
 |
||||||||
|
Line up each banner rail with each IH clamp and place
the tear drop side up. Slide onto clamp.
|
Screw banner rails securely onto clamp.
|
||||||||
 |
 |
||||||||
|
Slide the banner into channel of both top & bottom
banner rails.
|
Place endcap onto each banner rail.
|
||||||||
 |
 |
||||||||
|
If using standard mount, place in desired location
and tighten each screw.
|
If using a tilting mount, twist rod until mount is
in desired position and place mount down into pole.
|
||||||||
 |
 |
||||||||
|
Tilt mount to desired angle and tighten screws to
secure.
|
Tighten top screw to secure rod in place.
|
||||||||
 |
 |
||||||||
|
Attach acrylic bracket with angle tilting up to desired
position on each pole with provided screws.
|
Attach pocket to the acrylic bracket using the thumb
screws.
|
||||||||
 |
 |
||||||||
|
After attaching bracket to television(s) with provided
screws, line up holes with mount(s) and slide into place.
|
Finished Product.
|
||||||||
|
|
|||||||||
